aquapetz.com

asheesh wrote:The one that you have if its from CPU then you need to use a load capacitor.please give a search on youtube you will get plenty of videos
Instead you can buy a SMPS based Driver
http://www.ebay.in/itm/12V-10A-120W-DC- ... SwpDdVcAbM

I have CPU SMPS.

Dont know about load capacitor.

asheesh wrote:here is my setup and HC

Asheesh ji need your help to joint 20 LEDs of 10 watt each. How many SMPS need? I have 4 SMPS in. working condition and want to make 4 strips of 20 LEDs of 10watt. I will be use these strips occasionally so dont want to invest lots oyf money.

Sushant, Sai, Joyce da need your help also.

SCORPIO wrote:

asheesh wrote:here is my setup and HC

Asheesh ji need your help to joint 20 LEDs of 10 watt each. How many SMPS need? I have 4 SMPS in. working condition and want to make 4 strips of 20 LEDs of 10watt. I will be use these strips occasionally so dont want to invest lots oyf money.

Sushant, Sai, Joyce da need your help also.

Sir, what type of smps we r talking about, please share the ratings.

Sent from my HTC One_M8 using Tapatalk

hi Rajiv JI
1. are these CPU SMPS, if yes you may have to add a load capacitor inorder to make them work, just search on youtube you will get a lot of videos on it
2. if they are normal SMPS like Chinese drivers, then what are the output volt and Ampere of the SMPS
3. You have to add 1w 1 ohm Resistor in series to each led before adding them in parallel connections
4. if they are 12 v 1 AMP led then you would need 5 AMP 12v = 60 wat SMPS for each let stip